Aquaponics The no holes fishtank window

Ive been thinking about adding a viewing window to my fishtank because Im part way through moving and expanding my little system, and now would be a good time.

The new system is going to be a simple CHIFT PIST* with fewer points to go wrong compared to my current system.

The problem with adding a window is that its another point that could fail. The side of the IBC fishtank is flexible, and the glass window is rigid, and that never ends well.

So I thought Id run it through the invention engine and see if there was a safer way.

It came up with something it likes to call the "No Holes Fishtank Window".

Which is nice.



So, it turns out you could probably force an aquarium partially under water from the surface to make an interesting inside-out aquarium.

Its a little reminiscent of Woncos house, "Outside of the asylum".

A better viewing angle would be made from a wedge shaped aquarium made from two squares of glass, and two triangles for sides. One square sits flat against the side of the fish tank (the side you would be leaning against when viewing), and the other sits at an angle of 45 degrees, so that it meets the other square 40cm underwater.

The entire device is mounted on a bracket that keeps it underwater. The bracket is an inverted U shaped bar of stainless steel (stainless steel, so the fishies dont get all dead). One bit of the U is siliconed onto the side of the window, the other end has a locknut to attach it to the frame of your IBC.

It could be easily removed to clean, or to simply add to land fill.

It will probably work, and might look a bit like this...

I might even make one for my boat.

Surprise!

120 Things in 20 years is still alive!



*Constant height in fish tank, pump in sump tank

Read More..

Epic adventurer Solar boat progress

I made some progress today buy building the frame to hold the solar panel on my little boat.

Not a lot of progress, but a bit.

I was prompted by Dave, a solar panel exporter from China to make some progress, so here is the result.

I made it all out of 25mm aluminium pipe, and plastic plumbing fittings. It should work well enough once I tie or wire it down. I might add some wire tension as well to make sure it all stays where it should.

The best part of my new adult construction kit is that Im able to adjust any of it on the go with nothing more than my hands and some luck.

At some point I plan on building a solar tracker so my panel always points to the sun regardless of where my little boat is pointing.

As a result, I?ll need the design to be flexible enough to allow me to add electronics and some kind of actuators to raise and lower different ends, and sides of the panel.

The basic plan will see me sit at the end with the chair on the right, looking under the solar panel when Im sitting, and looking over the top of the panel when standing. This height gives an unrestricted view when sitting or standing.

When sitting, I wont cast a shadow on the panels even when the sun is setting directly behind me.

The panel will sit on top of the two bars and form the final bit of structure.

That should work.

Read More..