This is the state of things a week or so ago - prior to me discovering that I had utility cables running only a few inches below the surface and wouldnt be able to dig down.
My mustard plant, while it was still planted inside.
The current state of the greenhouse. I made it short because the townhome covenants say structures have to be no higher than the brick wall at the end of the property. FWIW, my next door neighbor is going to have to remove the fancy storage shed you see in the pics - not a happy thing to learn after youve spent time and $$ putting something in...
The grow bed that is up and running. I used hydroton because I needed to get one bed working to host plants that were inside, since I moved my indoor growbed outside. So nice not having to deal with gravel on the planting layer!
A bed prepped with gravel in the bottom. Theory is this will help anchor plants that would tend to fall over in hydroton or shale aggregate. Besides, it displaces $$$ of the more expensive lighter stuff, and it is already pregnant with the happy bacteria that transform ammonia to nitrate.
Im waiting to get expanded shale aggregate for the final beds - having a local business special order it from Bigelow Brook Farm and TheAquaponicSource.com.
A shot of my bell siphon, showing the 45 degree bend and my new sliced drain tube. I have a small hole at the base of my standpipe so any extra water can drain out when power goes out (like at night if I turn off the pump). The good thing is I wont have plants drowning in standing water. The bad thing is I always have a small dribble. This sliced drain tube takes the trickle down to the water surface (no noise) and still lets the siphon break. It ingests air into the flow, but keeps the noise of the full siphon action pretty low.
Heres a detail of the construction. Because my townhome covenants require me to keep this thing really short, the PVC sleeves allow me to temporarily raise the roof an additional 24 inches. Its also more forgiving than EMT couplers would be. I drilled through the PVC and EMT and connected them using a toggle bolt - looks kind of spiffy, I think. I should have painted the PVC to extend the life of these legs, but it wont be too hard to replace them. Lets pretend I am leaving them unpainted on purpose, to see how long it takes for them to become so brittle they dont work anymore... Since the PVC sleeves arent load-bearing, I should be good for a long time.
I used 10 foot wide sheeting, so had to join the roof sheeting with a 5 foot wide side piece. I did this by connecting the two sheets and rolling them around EMT conduit, then screwing the conduit to the frame with 2-hole straps using self-tapping screws.
The 2-hole EMT straps can also be bent so they serve as clips - useful for fastening the plastic until I have my end walls built.
Finally, a shot of my rain barrel. We made this at a county workshop using 65 gallon pickle barrels. It would be relatively simple to update the greenhouse design to include rain gutters if the greenhouse wasnt close to another water source. I dont have solar panels (yet) but the pump and bubblers draw in the neighborhood of 120 watts. Seems it would be perfectly possible to power a system like Ive got here off solar, particularly if you shut the pump off at night.
So, those are the pics. Enjoy!
Sabtu, 07 Mei 2016
0 komentar:
Posting Komentar